Rieke/Stolz Vented Pail Closures

Micro-Porous Vents

Many of Rieke Packaging Systems plastic pail closures can be equipped with a Micro-Porous Gauze Vent that allows two-way venting for either pressure or vacuum relief.

FS 10-10-231 TFE-1 VENT
Description

When using these vents:

• Be sure to allow for adequate head space (outage) in the container. Failure to do so can plug the vent or cause leakage
• The container should be transported and stored in an upright position

FS 10-10-231, FS-14, FS-15, FS-60, FS-70, FS-80, FS-80T, FS-632, SC63R, TFS-1, TFS-1PNote: Add the “TFE” suffix to the part number when specifying a micro-porous vent.

Reversible Vents

Chemical manufacturers appreciate the design capabilities of Rieke Packaging Systems reversible vents. Formulated with two special synthetic materials (Buna and EPDM), these vents meet compatibility requirements while accommodating pressure and/or vacuum relief.

FS 10-10-PV21-P or PV21-V
Description

A reversible vent can be incorporated into any of the following plastic pail closures (including that which is shown):FS-10-10, FS-14, FS-15, FS-60, FS-70, FS-80, FS-80TNote: Add the “PV-21P” (pressure) or “PV-21V” (vacuum) suffix to the part number when specifying a reversible vent - available in Buna or EPDM

Stolz Vented Pail Closures

K20-52 PV A
Description

Pressure/vacuum relief closures for plastic pails

K25 Sk PE A
Description

Pressure/vacuum relief closures for plastic canisters.

Stolz Plastic Seals

k46 SI B A

K48 SI A